How To Clean The Flat Screen Printer

In addition to the content described above, the pin clips and pin plates of Flat Screen Printer should also be cleaned regularly, usually once a week.

Under normal circumstances, the Stenter can not work on the same type of door width for a long time, but it should be replaced with a different type of door width every time. This prevents premature wear on the splined spindle. In daily work, the operator also needs to constantly check whether each stroke switch of the tenter is sensitive and effective.
    If any damage is found in the inspection, it should be replaced in time. The amplitude-adjusting screw inside the drying room of the tenter also needs to be cleaned frequently, generally once a month. If the equipment used is of the oil-heated type, the filter on the heat-transferring oil pipeline should be removed and cleaned at least every six months. You can continue to use it after cleaning.
    If during the daily use of the tenter, it is found that the oil pressure has decreased, or the temperature has increased relatively slowly, then it may be due to a clogging problem in the filter, and it should be checked and processed in time. If it is electric heating, then you also need to frequently check whether the electric heating tube has abnormal problems. If the current is not flowing, it should be replaced in time.
    Normally, after ten days of continuous use of the tenter, the filter should be washed to remove the fluff that has adhered. In addition, the hot air circulation system should also be cleaned frequently, especially the spray pipe needs to be cleaned once a month. * For exhaust fans and exhaust pipes, generally check and clean every 3 to 6 months to avoid accidents.
   In addition to the content described above, the pin clips and pin plates of Flat Screen Printer should also be cleaned regularly, usually once a week. At the same time, the oil in the oil pan on the exhaust duct needs to be cleaned once a week.


flatprinterlicheng

2 Blog Posts

Comentarios